fixed wireless terminal (FWT) can provide the following data services:
- Internet Access
- File Transmission
- PC Fax
Before using data services, please make sure your FWT has been powered on and work normally.
Please refer to the User Manual for the operations about this part.
Note:
Microsoft and Windows are registered trademarks of Microsoft, and VentaFax is
registered trademark of Venta Association.
Precautions
When using data services, users must pay attention to the following points:
- The FWT works normally;
- Your computer works normally;
- The connection between PC and FWT should be reliable. Don’t pull out USB cable
unless PC prompts “Can’t find USB MODEM”; - The area where the FWT is located must have network support
- The driver has been installed correctly
- Make sure the local other networks are disconnected;
- Please don’t connect LAN simultaneously to avoid the network disconnection of FWT;
- Please don’t exit from the application during the connection or disconnection.
Disconnect before exiting from application; - Don’t disconnect or exit right after the connection is made because it will easily cause
the uncompleted disconnection. Sometimes you need to restart the FWT and insert USB
data cable; - Please close the dial-up application/hyper terminal application/fax application firstly and
then pull out USB data cable connected with the FWT after you finish using the data
services.
System Requirements
FWT supports the following operating systems:
Windows 2000
Windows XP
Minimum system requirements:
CPU Pentium-II/233MHz
USB Interface 2.0 (compatible with 1.0 & 1.1)
CD ROM CD-ROM drive (used for installation only)
Memory 64 MB
Hard Disk 30 MB
Post a Comment